adding pressure sensitivity to ps3 controller on pcsx2

If my Logitech gamepad is the problem, can you guys suggest gamepads that do have pressure sensitive buttons? If it isn't, how do I get LilyPad to show that button pressure is indeed being accepted and not simply directly jumping from 0.000 to 1.

It works fine for like 99% PS2 games since they don't care about how hard you press the buttons, but I'm trying to replay The Bouncer out of nostalgia - it was my very first PS2 game - and whaddya know, that game has pressure sensitivity to all 3 attack buttons. To contrast, the analog sticks correctly show gradually increasing 0.xyz values.ĭoes this mean my gamepad hardware doesn't have pressure sensitivity for the buttons other than the analog sticks? It's not an expensive pad but it's not one of those cheap ripoffs either - it's a usb Logitech dual-action (p/n: 863247-0010) gamepad. Opened up the config and looked at the settings:Īs you can see from the screenshot when I clicked button 2, it went straight from 0.000 to 1.000, with no inbetween values. Youll need to press the PS3 button on the controller while binding controls or in-game to initiate the connection (Just have to do it once per reboot/plugging in the DS3).

You may have to restart pcsx2 to see the bindings properly take effect.I read that LilyPad supports pressure sensitive buttons, so I was curious why I had to use the kludge for the infamous Star Ocean 3 dragon flute thing. Check DS3 native mode in the LilyPad config, then bind the DS3 controls. Select pad 1, bind your controls normally. Open Lillypad, on the main page and uncheck Direct Input support. In pcsx2 open the controller settings and select controller 1 on the left panel in the very center is an unmapped key for pressure modifier. (Thy will look like blue rectangles that appear) Then press ESC to close the game and return to pcsx2. THIS STEP IS IMPORTANT! Start a game in pcsx2 and watch for some steam indicators in the bottom right. Select Racing Wheel as the Controller: Within the. Once the emulator is running, navigate to the Config menu and select Controllers (PAD) to access the controller settings. select browse and look for and select pcsx2 to add it into steam. Follow these steps to set up your racing wheel in PCSX2: Launch PCSX2 and Access Controller Settings: Start by launching the PCSX2 emulator on your computer. Back out and close Big Picture mode to return to the desktop client. pressure-sensitive face button functionality of the original PS2. then install the dualshock 3 driver again via scptoolkit and it should work.also note, do not cancel the installation or uninstallation of the driver, unless it takes more than 5 minutes. You can enable Xbox support if you want custom mappings from steam. added yet And if not is it something that. first uninstall the PS3 driver you installed via scptoolkit, then reboot your pc. Select the cog in the top right and select controller settingsĮnable Playstation or whatever non Xinput controller you're using. I was looking for some info and I read a bit about SCP for DS3 and also found about this. Controller I was wondering if I could use my PS2 controllers (DS2) on the PCSX2 emulator with the pressure thing enabled. Open steam and select the white square in the top right corner to open steam big picture mode PCSX2 with PS2 controller: pressure sensitive buttons - plz help. (We can’t have any other software like DS4Windows) Hello and welcome to my brief yet comprehensive tutorial on how to set your controllers up with steam and pcsx2.įirst off ensure steam is installed, and that that steam is the only program running.

Adding pressure sensitivity to ps3 controller on pcsx2